|
Lube oil, BFP, & H2 seal oil coolers are
baked in a high PH Chemical solution for 12 hours, then at a low
ph for 3 hours. The
ph of the solution is brought to neutral(7-8Ph).
The cooler would then be pulled from cleaning vat and sprayed
with a high-pressure washer to remove loose debris and excess chemicals.
After this, each individual tube is rodded out with pneumatic
drill brush. Tubes may be tested for leaks and if necessary, plugs
may be installed on site.
Please visit
www.CoolerCleaning.com
for more information.
© 2000-2006 Benchmark
Services, Inc. All Rights Reserved
|
